How to measure and find your Spa Filter
The quickest way to identify your Filter
We can always find the correct filter for your spa from the wide range of filters that we keep in stock. One of the quickest ways to identify your filter is for you to send us the measurements. However, it is not as straight forward as it might first appear. I have therefore made this guide to show which measurements are need
Bill Norris, 31-03-2015
Sercrets of a Pump Wet End
I thought it would be useful to dedicate this article to Wet Ends and to bring to your attention some of the characteristics that are not immediatly apparent and pull together some of the answers to the many questions that we continually receive about Wet Ends.
Bill Norris, 31-03-2015
How to measure pipework - it's complicated!
I wanted to explain the importance of finding the measurement of pipe to make sure that all our customers understand and are able to order the correct part and to avoid the inevitable confusion.
Bill Norris, 16-10-2014
How can a 56 frame wet end be two different sizes?
Currently we stock a wide variety of wet ends to fit to existing pump motors out in the field.......
Bill Norris, 14-04-2014
How do I upgrade a Chinese system that has 3 equal rated pumps?
In more recent years, Chinese manufacture Hot Tubs have tended to come through .....
Bill Norris, 14-03-2014
Ozone Check
Always check the customers Ozone with every service you provide.
Bill Norris, 21-02-2014
Heating out old pipe...
Sometimes when you have to repair a plumbing joint or replace a pump, there just isn't anywhere to find a clean section of pipe to cut back and work from.
Bill Norris, 20-02-2014
Replacing a Laing Circulation Pump?
A technical tip to save a lot of time.
Bill Norris, 20-02-2014
Save time on a drain-down with an Ahh-Some product
Using this Ahh-Some product can really save you time when you are doing a complete drain down and clean.
Bill Norris, 20-02-2014
Identifying Balboa PCB's
How to make sure that you order the correct Balboa PCB
Bill Norris, 19-02-2014
Welcome to our new blog post
Welcome to our new blog post
Bill Norris, 18-02-2014
